National Cable Quality Center: strictly control the qua…

　　Video machines, is a way to suppress the hardware to the terminal, then a conducting wire processing equipment. For terminal machine played terminals, we generally need to be tested, in order to put on the market after reaching the standards. Then hit the terminal terminal machine, how should determine whether they qualified it?

　　In general, we have to check whether the terminal machine terminals qualified to play, you need to be judged by the terminal section of the analyzer. Which is mainly through cutting ---- grinding and polishing ---- electrolysis (corrosion) ----- observation four. In the process of observation, we can be judged according to the following situations terminal is qualified:

　　1, skinning opening length

　　Stripping opening the same length indicates the terminal qualified. If the length varies, then failed. Generally, the opening of varying causes are many. The most common such as sending wire wheel too tight or loose; just use it to fine-tune pieces of rolling wire wheel to adjust the gap between the two rounds as well as flattening and not too loose wire slippage can be adjusted. If it is because cutting and stripping knife to cut too shallow or too deep; then we can use to debug cutter blade depth adjustment member to the appropriate location, so as not to hurt the wire and can successfully shedding rubber prevail. If you're still opening different, then it would be directly replaced with new cutting blade.

　　2, exposed copper crimp terminals evenness

　　If uniformity different, then failed. This requires us to check whether gun-type arm catheter and the wire with attached together; terminal machine blade and arm are relatively straight catheter; auxiliary briquetting machine terminal is loose; terminal machine and check the distance between the presence or absence of changes in automatic machines.

　　3, terminal machine starts are normal

　　If the terminal is unable to start or stop the operation, the outgoing terminals also reach eligibility requirements. This requires a firm to check whether whether the current input and 6KG pressure and the presence or absence of a functioning part of the wire or stuck; still checking whether the signal connection terminal machine or power connection does not lead to a terminal crimping machine.

　　4, electronic wire cutting length

　　Cut the same length, the terminal qualified. If not, it may be worn or tangential knife blade edge; encounter this problem should be replaced with new cutter. But it may be because sending wire wheel too tight or too loose; this time we can roll the line between the two rounds of the adjustment wheel to fine-tune the gap and even pieces of wire flattening and not too loose slip.

　　Generally speaking, we basically can be determined by more than four terminals are qualified.

　　 News From: wire and cable equipment, cable equipment, cable equipment, Dongguan, Dongguan extrusion machines, stranding machines in Dongguan, Dongguan CD-ray machine, extruder professional manufacturer in Dongguan, Dongguan City, Hongye Fu wire and cable plant, URL: www.hongyefu.com